Hello
I have a question about the value of L1 and L2 of the TX136KHZ
on the circuit it is marked L1 and L2 680n (0.68uH) ??
TX is ok but 10mHz transverter no ok I replace IC2 no change .
HUBERT
* * * VALUE L1-L2 TX136 * * *
Re: * * * VALUE L1-L2 TX136 * * *
Hubert,
The value 680nH is correct. L1, L2 and C11 forms a 12MHz LPF filter to attenuate harmonics coming from the mixer IC2.
Check first that the 10MHz square wave (CLK/2) is coming to IC2 pin 14.
Matti OH7SV
The value 680nH is correct. L1, L2 and C11 forms a 12MHz LPF filter to attenuate harmonics coming from the mixer IC2.
Check first that the 10MHz square wave (CLK/2) is coming to IC2 pin 14.
Matti OH7SV
Re: * * * VALUE L1-L2 TX136 * * *
Matti
thanks, i checked the signal on pin 14
bad solder
. now the converter works well.
73 Hubert
thanks, i checked the signal on pin 14
bad solder
. now the converter works well.73 Hubert
Re: * * * VALUE L1-L2 TX136 * * *
Very good Hubert,
Enjoy using your JUMA TX136.
Stay safe!
73 Matti OH7SV
Enjoy using your JUMA TX136.
Stay safe!
73 Matti OH7SV
Who is online
Users browsing this forum: No registered users and 4 guests