Howto putting Software into new PIC?

[DG4FCO]

Hi!

As I read, Software-Updates will be done via PC into a running Juma.
But, if I need/want to put the software in a fresh PIC (IC9 oin DDS), how to
do this? The programming pins go to ICD2/J19, so it should be possible.
Is there a small HowTo, because micro-controller programming is not
my main business

I think this way is easier and faster than asking the Juma Boys for a new
Chip just because I am to heavy-handed for a QFP80.

I got a MiniPro Programmer (TL866CS) with a QFP32 Adapter. So I also can
get a QFP80 Adapter and programming it outside the board. And got a little bit
knowledge as I did "programmed" some other controllers with this Mini-Programmer.

Thanks in advance

72/3 de Frank, DG4FCO

[DG4FCO]

<self-reply>

Found a article from 5B4AIY (date 15 Mai 2016 12:33) which describe enough for me.
Also included a description and the firmware with bootloader.
I think this will work

72/3 de Frank, DG4FCO