Juma PA-100D v3.0c Build 6

[5B4AIY]

This version is a maintenance build. It does not introduce any new features, but simply cleans up some code, and fixes some minor inconsistencies. For full details, read the comments in the file juma-pa100.c at line 481 onwards which covers version 3.00c.

This version can be safely loaded over the previous version 3. If loading over an earlier version, be aware that as the EEPROM mapping has changed as new features were added, that this will cause a 'Checksum Error!' message on first switch-on after loading. This is perfectly normal, and only occurs the first time. Please make a note of your existing calibration and configuration settings prior to loading this version.

If you are updating from an original firmware (Versions earlier than 2.0) then as the measurement system is completely different you will have to re-calibrate the amplifier.

73, Adrian, 5B4AIY